Recent content by beavermatic

Re: Wondering If I have "angry sparrows" cv and if so, what do i need to buy to fix i Is it allways going to be related to the front drive shaft? or does it occur to the rear as well?

Wondering If I have "angry sparrows" cv and if so, what do i need to buy to fix it Within the past couple weeks, I've notice a slight squeak coming from my jeep ('05 Wrangler Unlimited), when going over bumps in the road, even small ones. It doesnt seem to occur until 10 or 15 minutes into...

Steelheadz, sounds like the way to go... but can you weld directly to the cast iron block? thats our only question at this point. Not sure how well a cast iron weld would work

stell headz, the two upper OEM bolt holes are gone, they broke off. They are not stripped out... they're completely gone. The third OEM bolt hole is split in half.... any suggestions?

stellheadz, aprpeciate the suggestion, i will let him know. He was also considering getting the bullet proof mount bracket, and then trying to fix the OEM holes by using some sort of German high end JB weld to remold the (2) broken OEM holes. If you notice in the pic, theres a hole to the far...

My buddy just bought a nice low mile 01 TJ, and upon inspection after hearing some noise, he notice the fan shroud was busted, and upon further inspection, notice that the motor mounts didnt seem right, and had a "wedge" piece of diamond steel between the OEM bracket and the 3 OEM mount holes on...