Latest activity

I want to post an update for this issue because I am having an issue. In this first image you can see my fuel gauge without the...

yes sir

At this point I think I am going to stick to stock from Quadatec because one Stock is more reliable and two cost but I am still...

Hello everyone.i read all the posts,i am from greece i have in my shop a jeep grand Cherokee 98 v8 with the same symptoms of battery...

At this point I think I am going to stick to stock from Quadatec because one Stock is more reliable and two cost but I am still...

they are trying to sell you something so they are going to say that. i have run 3 inch lifts on two 87 model jeeps with control arm...

they are trying to sell you something so they are going to say that. i have run 3 inch lifts on two 87 model jeeps with control arm...

The front and rear ratios need to match unless you want to do a complicated front/rear tire size mismatch (not recommended). IMHO, you...

Yesterday I had a 45 minute conversation with a tech at Quadatec from this, I was told that to do a 3" lift I have to get in this case...

Did you discuss the paint sag with them? Personally that sag would bug me every time I used the jeep since it's on the driver's side.

Got the lock replaced before they scrapped my old door. I'm just gonna live with the paint & never take a vehicle there again.

Thank you

I have a 1987 Jeep XJ rear axle is a Dana 44 with 3.07 gears. I have a manual and the 4.0 the front axle is a Dana 30 if I wanted to...

Thank you

Not with a 3 inch lift. You can if you want to but you dont have to. The angle of the control arms wont be bad