Recent content by xtremryd

Does anyone know about how much 4:56 gears cost!

I have 2 JBL 10's running on a 600 what kenwood amp. Run the wire through the fire wall on driver side. Pull the carpet back locate the rubber firewall gasket with all other wires through it, take a knife cut a small slit to enlarge the firewall hole. Run the wire through up and around the...

Super swamper LTBs Cherokee's have small wheel wells and the backspacing tends tp keep them tight under the well. To fit a atleast a 31" tire a 2" lift is atleast required. Daystar sells the 2" coil spacer and 1 3/4" rear shackle for about $85 Because cherokee's have such high backspacing the...

If vibration happens when you brake check the rear break drums. I busted my rear drum and when i started to break from around 55 mph my steering wheel chattered backa and forth like no other, i had the drum replaced and the vibration went away. A cv driveshaft is around $250- $300. Vibration...

Four Real Bumper Daystar, rubiconexpress.com, rustysoffroad.com, the kit is normally about $92 i know from daystar and that's with shipping included.

Not possible for body lift on unibody frames. You can get a kit from daystar for a quick 2" to fit 31" tires. The kit is a 2" poly coil spacer and a 1 3/4" rear shackle.

Yes, also go with a full leaf pack. Stock always likes to invert a little and adding a add-a-leaf i believe won't help enough to get the desired height. I believe the higher you can afford to get the more you'll love it. I'm only 19 and Lifted Cherokee's are magnets to the women no kidding!

re 35 or 44 I drive a 2001 Cherokee sport. I installed a 5.5" rubicon express lift onmy Jeep, my other option was the Rusty's 6". You will be told that you will have a lot of vibration because of a higher lift, thats all bull, its very little. Most that vibration i feel comes from the tires on...

XJ and TJ have the same connections points when it comes to axels and almost any other part on the two. A lot of Tj will use the front end off an XJ an to replace the stock of a TJ. So a 44 of another TJ or XJ will work with no problem. But I am not sure about putting a 35 rod inside a 44...