Search results

Would a 600cfm 4bl carb be to much for a stock 89 4.2 other then 4" lift and 33's ?

Okay so today I finally finished my posi lock mod (home made) and the 4wd dose not seam to work. When I had the jeep on jack stands and pulled the cable to engage it all four wheels turned, but when I took the jeep out to the field by my house it only seamed to work for a very short time. I then...

Here can I get the rubber boots that cover the hole where the clutch fork is and the one for the hydraulic clutch?

I have this knocking noise that happens on acceleration, it does not do it when idling. I checked the timing and set it to 16 degrees like the specs say to. Set the timing by plugging the vacuum line that runs to the distributer and unplugging the electrical wire on the valve cover like the book...

Have an 89 yj with carter carb.. Question is how hard is it to rebuild the carb? I've never really worked on carbs before other then on small engine carbs like law mowers and atv's. I noticed some leaking around the gaskets of my carb today

So took the jeep to emissions today and it failed. Any ideas on what to do? Carbon monoxide to high at 94.83 standard is 25.00

Hey guys I'm new here been looking around for a while and have a couple questions if I can get some help. I have a 1989 yj 4.2 with a4 speed trans stamped on the side T-98 and a 231 transfer case. One of my questions in would it be okay to run a 3/8 rubber fuel line to the mechanical fuel pump...