Recent content by BENT

thanks guys for your help. its greatly appreciated.

i realize that most of you guys dont agree with shackle lifts. but is there an amount of shackle lift thats ok? heres the situation, i have a 4" suspension lift,(probably only 3" now, its a few years old) and the bolt holes in my shackles are worn, so i need new shackles anyway. now my question...

if you must take it in to the shop, and it just needs to be bleed its a 10 min job. but im sure the shop will find somthing else to make it an hour.

bleed it yourself, its simple. take the top off your clutch master, top it off with fluid(leave top off). get under the jeep and loosen the bleeder nipple alittle bit until the fluid is running slowly. then get under your hood again and keep on topping up your master with dot 3 brake fluid...

if it does build up pressure when you pump the clutch, and go into gear then you probably just have air in the line.( thats if the master and slave are new.) try gravity bleeding it, thats the only way that worked for me. if when you have it in gear and the clutch doesnt slip or anything...

someone get the grease gun! haha

try gravity bleeding it like i mentioned above, and if that doesnt work you probably do need a new master cylinder. i got a new clutch put in also, including slave cylinder, and i tried bleeding it every which way and nothing worked. so i got a new master and gravity bleed it and never had a...

how long ago did you put it on? did it work when you first put it on, and now it doesnt. or did you even put it on yet.

SYE question after i replaced my clutch, it did the same thing. try gravity bleeding it, loosen the bleeding nipple on slave cylinder and keep topping up the reservoir until the fluid coming out runs clear, then tighten the nipple again. if that doesnt work, chances are you need a new master...

hello, and welcome to the board. i have the 4'' procomp and i never had those problems. is it just when you hit bumps that it sways?or all the time? check your sway bars. and also did they put the drop pitman arm on?(coming off your steering box). and how big are your tires. if you have soft...

mine did the same thing. do to flapping of the top,the screws wiggle loose, and as the top flaps it ripped the screws out of the frame therefore stripping the holes. there is alot of force on the top when you are at highway speeds. heres what i did to mine, if the metal around the screw holes is...

flip124 it depends how thick the build up is. you might have to scratch some of it off first, then i use "simple green" and let it soak for 10-15 min, then blast it off with water, and redo if necessary.

they are an awesome looking top. it has to be pretty cold before i put my hardtop on, it just doesnt look the same.

the tj has a different mounting setup than the yj, so i dont thing they are interchangable, but they should be the same top. some of my friends have them on thier tjs, and they look the same

Where to fit my spare? i have a california soft top on my yj. im from edmonton and am friends with the owner who makes the tops himself, and i think they are the best tops around. i have the spice full soft top and a three piece combo. ive had both for about 4 years now and they both look and...